Wall panel finishes
Find the finish for your space.
Six finishes in two collections, Desert and Mineral, plus bespoke colours.
Decorative wall panels, cast through the material rather than decorated on top. Colour, veining and texture form during casting. Select the finish from physical samples, seen in the light of your project.
Desert
Warm earth tones
Desert Sand
Pale cream, softly clouded. Movement is slow and wide, with little contrast between the drifts.
Request a sample →
Rosso Sand
Warm terracotta with fine drift. Reads pink in north light and clay in low sun.
Request a sample →
Travertine
Warm ochre with an open, stone-like surface.
Request a sample →Mineral
Fine-grain greys
Lime Stone
Pale grey with open pitting. The most stone-like of the casts, and the most tactile.
Request a sample →
Gypsum Sand
Grey and white, softly marbled, with open pores where the mineral settles.
Request a sample →
Ash
The deepest cast. Charcoal through the body, with pale mineral surfacing in drifts.
Request a sample →Not sure yet?
Compare them side by side.
We send a physical set of the finishes, cast in the workshop.
Request the sample set →Bespoke
Custom colours
Mud Earth
Deep earth brown, heavily marbled. Mud Earth is one of our bespoke casts — we welcome bespoke colours, so tell us the tone your project needs.
Discuss a bespoke colour →Textured wall surfaces
Textured wall surfaces for project interiors.
Each finish is a cast mineral surface, not a printed image of stone, concrete or plaster. The variation is physical: fine grain, open pores, mineral drift and panel-to-panel movement. Use the collection to choose the visual direction, then confirm format, fixing and documentation through the Product and Technical Documentation pages.
Are the finishes printed or coated?
No. The colour and movement are cast into the mineral panel. The visible face is the panel material itself.
Will the panels match exactly?
No. Rumett panels are cast, so tone, veining and surface movement vary. Physical samples should be reviewed in the project light.
Can every finish be used on Vela?
The Vela page shows the available floor-screen finish options. Confirm current finish availability before ordering.
Every finish
The same panel, in six surfaces.
The colour goes all the way through. Cut a Rumett panel and the face continues into the body — no printed layer to wear off at an arris, no paper core at a cut edge.
Colour on a screen is a starting point. The finish is selected from physical samples, in the light of the project.
Next step
See it in your own light.
Tell us the room and the light it gets, and we will say which finish we would put in it. If the project is already defined, send the area, location and timing for a quote.